JUST A QUICK QUESTION!
Thread Starter
Member
Joined: Apr 2007
Posts: 174
Likes: 0
From: The Boot(New Orleans) Louisiana
Car: 1986 Irocz28/04 GMC Yukon
Engine: Ram Jet 350(*TPI*)
Transmission: Turbo 400 w/1500 stall
Axle/Gears: 3.73
JUST A QUICK QUESTION!
I HAVE CHANGED MY CAR FROM A 305 TPI TO A RAM JET 350. SHOULD I CHANGE MY MAF SENSOR? I BOUGHT IT 1 WEEK B4 I DECIDED TO SAY SCREW IT AND PUT A BIG BOY MOTOR IN. JUST WONDERING BECAUSE WITH MY OLD IROC I AHD A 383 AND I LEFT THE 350 MAF SENSOR IN IT AND IT SEEMED TO RUN FINE. I WOULD APPRECIATE ANY HELPFUL INFO!
Last edited by RocsRose86; May 9, 2007 at 10:08 AM.
Member
Joined: Feb 2001
Posts: 175
Likes: 0
Re: JUST A QUICK QUESTION!
There are a lot of factors that you have left out. Did you change prom chips 305 to 350? Is this just a stock 350 with a ram jet intake? It would be in your best interest to use the maf unless you have the ability to custom tune your prom chip. This seems to be more of a diy prom board question.
Thread
Thread Starter
Forum
Replies
Last Post