ok, i have searched, found, and asked the questions but i've had no luck with responses, so i'm bringing it to the electrical gods in this forum.

I recently did my H4 diamond headlight conversion kit (yes i did, and it was because it was cheap, so now i'm paying for my "cheapness") i got the APC wiring did it all like i was supposed to (i even kept my fingers off the actual bulb). It worked great for a few minutes, then i drove to a friends house, and by the time i got there the smell of burnt plastic was in the air, so i check my headlights and sure enough, the passanger's side low beam blew up, i re-re-checked the connections and everything seemed fine.

now i'll admit it, i hate wiring cuz i suck at it , so if you guys have any suggestions on how to upgrade the APC upgrade, or if any of you guys have done it, i would really appriciate some help
thanx in advance