did a vats swap....
Thread Starter
Joined: Apr 2006
Posts: 1,022
Likes: 5
From: Santa Ana, CA
Car: 90 IROC-Z
Engine: Lsa
Transmission: M6
Axle/Gears: 9" spooled 3.70
did a vats swap....
Yes I did it correctly swapped the entire column and pass key module and I'm using the key that is compatible with both. the car was cranking and running fine (except for my fuel pressure issue) but the point is it was successful. Well I go today to start the car it turns over for a split second then nothing. It will click if I hold the key to the on position after a few seconds. Its throwing a code 46 which is vats related but the security light goes off. what the hell?! the only possibility is the chip is kinda worn.. but could it cause a code 46? any help appreciated 
Supreme Member
iTrader: (3)
Joined: Feb 2003
Posts: 2,065
Likes: 0
From: California
Car: 1982 Trans Am & 1982 Corvette
Engine: L-98 with LO-3 induction. 350 CFI
Transmission: 5 speed and vette has 700r4
Axle/Gears: 373's in T/A .. vette unknown
Re: did a vats swap....
I had this code once and it was the decoder box. Ive never had a worn key cause it though.
Thread
Thread Starter
Forum
Replies
Last Post
86White_T/A305
Third Gen Association of Ontario
0
Sep 21, 2015 05:28 PM
