guage cluster help needed
Thread Starter
Member
iTrader: (4)
Joined: Dec 2003
Posts: 164
Likes: 0
From: forked river new jersey
Car: 1986 firebird trans am
Engine: 350
Transmission: 700r4
guage cluster help needed
is there any differance between the circut board on a v6 and v8 guage cluster or are they both the same?
iv got a v6 guage cluster and a v8 guage cluster and sense im doing a v8 swap in my car i want to install the v8 one for the tach. but the curcuitboard on the v8 cluster has a few rips in it. is it possible to take the curcuitboard off the v6 cluster and put it on the v8 cluster or maybe easier is it possible to take the yellow thing. which im asuming is what controls the tach off of the v8 guage cluster and install it on the v6 guage cluster ??
iv got a v6 guage cluster and a v8 guage cluster and sense im doing a v8 swap in my car i want to install the v8 one for the tach. but the curcuitboard on the v8 cluster has a few rips in it. is it possible to take the curcuitboard off the v6 cluster and put it on the v8 cluster or maybe easier is it possible to take the yellow thing. which im asuming is what controls the tach off of the v8 guage cluster and install it on the v6 guage cluster ??
Thread Starter
Member
iTrader: (4)
Joined: Dec 2003
Posts: 164
Likes: 0
From: forked river new jersey
Car: 1986 firebird trans am
Engine: 350
Transmission: 700r4
Re: guage cluster help needed
figured it out aparently i can just remove the entire tach as a complete unit from one cluster and install it into the other
Thread
Thread Starter
Forum
Replies
Last Post