I need the IP connector pinout for a 87-88 MAF TPI (clear connector on the harness by the ECM). I'm installing the harness in a 86 Monte SS and I am pretty sure they will not match up. From what I researched there are a few I will need to correct, and re route in the SS harness. I have a GM service manual for the SS, but not for the TPI. I can take a few pics of the connector if it will help. Does anyone have this??

Thanks!
Scott.

 

Honestly, I don't understand the silence. I'm a car enthusiast just like the rest here. I've never got this cold shoulder from any other site. What gives with you guys? This system is a thirdgen system. If any one of you needed help, and I had the answer, I would give it to you gladly. Especially if it would save you time and head ache. I would just like the same in return.

 

read the rules and youll know why you have no response

 

Might find something here, has gauge wiring diagrams for other years (85/89 )which would be similar
http://www.austinthirdgen.org/mkport...ntents/images/

Why would that be?

 

?

 

Would probably help to know what car it came from as the IP connectors may be different... Where it's going doesn't matter as much.

 

So I'll not get a response since the third gen system is not in a third gen....if I hear you correctly. I didn't ask a G body question, I just said I was installing it in the G body.

Since the computer system came from an 88 IROC with a 5 speed, and since they are third generation......then here would be the logical place to ask.

aremy10, if you don't want to help, then don't. I'm not prodding you about this. I just asked an honest question, I'm not looking to spar. If I wanted that, I'd go to another site. I just have a car I'm working on, and need a little help, that's all.