84 TA ECM harness question--wire identification
Thread Starter
Joined: Dec 2005
Posts: 4,795
Likes: 15
From: St. Cloud, MN
Car: 1984 Trans Am
Engine: LS1383 in work
Transmission: Magnum F - to be installed
Axle/Gears: Zexel Torsen 3.73, 28-spline mosers
84 TA ECM harness question--wire identification
Hey guys,
I was splicing some melted wires on my ECM harness and came across a strange set up. It's a shielded two-wire group that's wrapped in black. I was pulling the black wrapping off when I noticed the shield and stopped. does anyone know what these two wires are for? I'll see if I can get some pictures up later if no one can picture if off the top of their head.
I was splicing some melted wires on my ECM harness and came across a strange set up. It's a shielded two-wire group that's wrapped in black. I was pulling the black wrapping off when I noticed the shield and stopped. does anyone know what these two wires are for? I'll see if I can get some pictures up later if no one can picture if off the top of their head.
Member
iTrader: (2)
Joined: Sep 2007
Posts: 180
Likes: 0
From: mesa, arizona
Car: 84 Trans Am
Engine: 383
Transmission: Tremec TKO
Axle/Gears: 10 bolt 3.73 lsd
Re: 84 TA ECM harness question--wire identification
IIRC those shielded wires go to the distributor, but not certain
Thread Starter
Joined: Dec 2005
Posts: 4,795
Likes: 15
From: St. Cloud, MN
Car: 1984 Trans Am
Engine: LS1383 in work
Transmission: Magnum F - to be installed
Axle/Gears: Zexel Torsen 3.73, 28-spline mosers
Thread
Thread Starter
Forum
Replies
Last Post
Billy Decker
Engine/Drivetrain/Suspension Wanted
0
Sep 4, 2015 03:46 PM
