Hi guys in this video I was working on a 91 GTA and took out the window motor...This video is intended to show you guys what it entails to take out a window motor..

its a junk car..so I didnt do it the right way lol...So i need to mention a couple of things about this video...
1) You have to lower the window to half way to do this job so it wont be under tension.
2) do not hammer on the window motor...again it was a junk car i didnt care
3) you do not have to use an air hammer..i did because i didnt care about the paint...if you want to be careful.just use a 1/4 inch bit for all the rivets..



Enjoy and please subscribe! thanks!

 

Nice!

I think there's a printable template for making holes to get at the rivets somewhere in the tech articles section so you don't screw up your doors.

This is also an operation every thirdgen owner will face sooner or later, so thanks for the guide!

 

Your welcome..although i should really edit this video to take some parts out LOL