melted connector
Thread Starter
Junior Member
Joined: Feb 2013
Posts: 24
Likes: 0
Car: 1992 Firebird
Engine: 3.1 L V6
Transmission: Automatic
melted connector
I have a 92 3.1 liter and i was looking under the hood and there is a connector that I don't know what it goes to, but it is melted some. It is near the Drier. Also if anyone can help me with ac problems that would be cool too. My cooling fan wont turn on and the clutch to the compressor won't spin either.
Re: melted connector
IIRC, when I was pulling my wiring apart, I though that connector was a little melty too, but it ended up just being old dialectric grease or something. I think that particular connector connects the HVAC controls to the rest of the engine harness.
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Lost His Cool
Originally Posted by Xphoidz
……My cooling fan wont turn on……
If it still won’t run the fan motor is defective.
If it does run remove the jumpers and make sure the fan is grounded.
If it is you have an open circuit from the hot in run circuit that was energizing the relay or the direct feed.
If it runs ground the fan switch in the engine.
If it runs the switch is bad.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
I’ll Bump You Once To Move You Over, Next Time I’ll Spin You
Thread
Thread Starter
Forum
Replies
Last Post
TMZIrocZ350
Engine/Drivetrain/Suspension Parts for Sale
1
Oct 7, 2015 12:09 PM
tmork454
Transmissions and Drivetrain
0
Sep 29, 2015 06:33 PM
