Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

Connector/Cut wire ID?

Old Feb 18, 2024 | 10:39 AM
  #1  
ill's Avatar
ill
Thread Starter
Junior Member
 
Joined: Feb 2024
Posts: 30
Likes: 2
From: Your Mothers House ;)
Car: 1991 Z28
Engine: 383
Transmission: 700R4
Connector/Cut wire ID?

Been looking everywhere for an answer to this and cant seem to find one anywhere but i have a 91 camaro z28 on the passenger side firewall theres 3 loose connectors. One is a 20amp fuse holder the others im still trying to figure out, if someone on here could help me out and lmk what these are for it would be very much appreciated!



Reply
Old Feb 23, 2024 | 07:25 AM
  #2  
Pocket's Avatar
Supreme Member
20 Year Member
iTrader: (24)
 
Joined: Jun 2005
Posts: 8,117
Likes: 362
From: NC
Car: 91 Trans Am
Re: Connector/Cut wire ID?

The fuse holder can be a number of things, factory or aftermarket. If it's factory or wired properly, then the red will be unfused battery 12v constant and orange fused battery 12v. A meter will confirm
I'd bet the fuse is protecting the fuel pump relay, again, meter

The black 4 pin connector next to it is the engine bay harness to HVAC mini-harness
The three wires are:
Red 12v batt to the blower fan relay
Blk blower fan grd
Lt blu AC request

Blk/pl and blk/orn are the original dual electric fan power wires. For GM fans, these go to the B terminal. A is direct ground
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
badtenant
Electronics
6
Apr 21, 2023 06:47 PM
BytePaul
Electronics
12
Jun 22, 2021 08:13 AM
Mason_99
Electronics
2
Apr 23, 2015 10:43 PM
305q_ta86
Electronics
15
May 13, 2006 08:30 PM
Abird4u2nv1
Electronics
3
Dec 23, 2003 11:35 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 12:00 PM.