When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
-What Gauge Wire needs to fit the Terminal?
-Does the the "Back-Side" of the Terminal (The Side I can NOT see in the Images) have a Locking-Tang?
-What is the width in "mm" of the "Pad" that the Wire-Insulation is against (Looks like Wings on each side of the Wire-Insulation)?
Just a bit of context...I'm trying to leverage the 4th Gen Fuse Box for my fans and fuel pump. I have a hotwire kit and just want to use this block to hold my inline fuse. So I'm just looking for the correct terminal However, the terminal from the hotwire kit fit in the block just fine and locked when I tried it. Just didn't have those fins on the side. Might be more trouble than it is worth. Some of those connectors seem to be hard to find...
Just a bit of context...I'm trying to leverage the 4th Gen Fuse Box for my fans and fuel pump. I have a hotwire kit and just want to use this block to hold my inline fuse. So I'm just looking for the correct terminal However, the terminal from the hotwire kit fit in the block just fine and locked when I tried it. Just didn't have those fins on the side. Might be more trouble than it is worth. Some of those connectors seem to be hard to find...
Main Fuse Box: 12176369
Small Terminal: 12110717
Large Terminal: 12092556
Here is the breakdown from the datasheet:
I should be able to find a solution for you.
Please just answer the 3 short Questions that I asked you in Post #5
