Skulte 4thgen wheel adapters!
Thread Starter
Senior Member
iTrader: (3)
Joined: Oct 1999
Posts: 535
Likes: 0
From: Reno, Nevada
Car: 1991 Formula L98
Engine: 350
Transmission: T-56
Axle/Gears: 3.73:1
Skulte 4thgen wheel adapters!
I am cleaning out my storage unit and found my set of 2.25" and 1.50" spacers. I used the 2.5" on the front with 9.5" ZR1 wheels and it put the wheels right at the edge of the wheelwell lip. The rear spacers are really meant for 11" wide ZR1's, because of their offset and extra width these spacers will also put the wheel perfectly in the wheelwell. I used them on 9.5" wheels, they sit in slightly more than 11" wheels but it's barely noticeable. They are from Skulte and have two new wheel studs since there were a couple that were slightly stripped. Good condition.
Looking for $200 shipped. Let me know any questions you may have.
Looking for $200 shipped. Let me know any questions you may have.
Supreme Member
iTrader: (1)
Joined: Aug 2003
Posts: 1,428
Likes: 0
From: SW Chicago 'burbs
Car: American Iron Firebird
Engine: The little 305 that could.
Transmission: Richmond T-10
Axle/Gears: Floater 9" - 3.64 gears
Will you take $75 shipped for the rear spacers?
Senior Member
iTrader: (2)
Joined: Jun 2004
Posts: 647
Likes: 1
From: South Jersey
Car: 1991 RS Convertible
Engine: 96 LT1
Transmission: T5
Axle/Gears: 3.45 9-Bolt
Re: Skulte 4thgen wheel adapters!
Still have them? I am interested in the 1.5" spacers. Who made them?
Senior Member
iTrader: (1)
Joined: Sep 2006
Posts: 962
Likes: 13
From: Canada
Car: 1979 Malibu
Engine: Blown LSx
Transmission: T56 Magnum
Axle/Gears: 9"/wavetrac/35's/3.70
Thread
Thread Starter
Forum
Replies
Last Post
punkmaster98
Interior Parts for Sale
0
Sep 8, 2015 09:45 PM