COMPLETE 3.5" MANDREL BENT CUSTOM EXHAUST
Thread Starter
Supreme Member
iTrader: (5)
Joined: Dec 2001
Posts: 2,873
Likes: 5
From: East Tennessee
Car: 1992 Z28 Heritage Edition
Engine: L98
Transmission: T56
Axle/Gears: 3.23:1
COMPLETE 3.5" MANDREL BENT CUSTOM EXHAUST
I have a complete setup for all 82-92 Fbodies.
It starts with a set of 1 5/8" Hedman shorty headers, then onto a custom 3" mandrel bent Y-Pipe, then onto a 3.5" mandrel bent Catback (minus the cat of course). Also has a cutout in place of where the cat would be. Ending it off with a 40 series (I believe) Flowmaster muffler and single 3.5" outlet/tip.
Its used, but it was good for low 11's.
I am looking for $300. Must pick up in Knoxville, TN or I can meet if close. Too big to ship.
It starts with a set of 1 5/8" Hedman shorty headers, then onto a custom 3" mandrel bent Y-Pipe, then onto a 3.5" mandrel bent Catback (minus the cat of course). Also has a cutout in place of where the cat would be. Ending it off with a 40 series (I believe) Flowmaster muffler and single 3.5" outlet/tip.
Its used, but it was good for low 11's.
I am looking for $300. Must pick up in Knoxville, TN or I can meet if close. Too big to ship.
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
Jun 13, 2021 01:13 PM
Street Lethal
Power Adders
634
Apr 30, 2019 12:14 PM





