Eats5.0's

iTrader: (1)

I bought this from a board member, probably 2 years ago, when I was still getting the motor rebuilt. After that came the trans, etc.. Out of the blue a "3.45" rear surfaced. I bought it without checking it, and lo and behold, it's a 3.27. Go figure. So, since I have a 3.27 rear, I no longer need these. The bearing is a little bent on the carrier, maybe from taking it off? It looks like a hammer/screwdriver mark to me. Not sure on condition of the cones, since I never installed it nor took it out of the box til now to take the pic.
Looking to get $125 shipped. Less than what I paid, but I think 3rd gen popularity is waning, so these may not be in that much of a demand.

I'm in Suffolk, VA, t_goat69AThotmail.com