I have a 96-99 truck 2 bolt main casting number '880' that is a hyd. roller block. It has been stroker clearanced and bored .030 over. Its to be honed but that's it....the cross-hatch is great in all cylinders but needs a little work in #4 so a hone is all this needed. Asking $300. Perfer not to ship but willing to drive a distance for gas money.

Located in SE GA.

Also have a stock oil pan if your interested...I'll include that with the block for free.

 

Bump...need it gone.....$250?

I will trade as well. Looking for a LC1, autometer guages, electric water pump, nitrous kit, or Cam in the 230/236 range.

 

interested, but will require shipping, i have a "hook-up" with fed ex as long as its less than 150 lbs

 

I can get it to a Fed ex place. Don't really know how much it weighs....two people can lift it without strain though. Would I have to go ahead and put it on a pallet?

 

Bump. Offers.

 

sorry on the delay yenko, found out my 95 already has an 880 block

 

Not a problem. Your 95 has had an engine swap them...the 880 came in the 96-99 Vortec 5.7L trucks.

 

some select 95's got the 880 block, not alot though, 95 was a changover year from flat tappet to hyd roller, ive been a few 880 blocks in 95's but far more flat tappet blocks

 

Cool. Didn't know about the 880 being in 95. I know the TBI system is still found on the 96-99 engines from Mexico.

 

Bump for $200 plus the ride!! Will to meet at a short distance for a small fee.