LS1/T56 w/ ECU and harness
LS1/T56 w/ ECU and harness
Ok, I have an LS1 from a 2000 SS, same with the transmission. This is a complete setup, you can install it in the vehicle of your choice and drive away.
Ported MAF Ends
LS6 cam
6.0L manifolds
CAI
complete engine harness
ECU has been tuned, tach set for 8cyl.
B&M short throw shifter
This was all pulled from my 84 Z28, no problems with the engine at all.
Asking $4500, it's ready to be picked up. Will have pictures later tonight or tomorrow.
Ported MAF Ends
LS6 cam
6.0L manifolds
CAI
complete engine harness
ECU has been tuned, tach set for 8cyl.
B&M short throw shifter
This was all pulled from my 84 Z28, no problems with the engine at all.
Asking $4500, it's ready to be picked up. Will have pictures later tonight or tomorrow.
Last edited by Saleen85; Nov 25, 2008 at 01:24 PM.
Member
iTrader: (4)
Joined: Dec 2007
Posts: 146
Likes: 0
From: Houston, Texas
Car: 1991 Camaro Z28
Engine: 305 LB9 5.0L
Transmission: 700R4
Axle/Gears: POSI 2.73
Re: LS1/T56 w/ ECU and harness
how many miles are on the engine and trany?...would you have any hp/trq numbers?
Thnx
Thnx
Re: LS1/T56 w/ ECU and harness
I was told there was 70k on it when I got the car, and I put another 5k on it since I've had it. I don't have exact numbers, but seat of the pants I would say it was around 320 at the rear wheels. My buddy dynoed 340 in is LSx swapped RX7 and I was about a car and a half off his rear bumper with both of us on street tires. He weighs 2600lbs, I weighed 3050lbs.
Thread
Thread Starter
Forum
Replies
Last Post
tgscooter
LTX and LSX
13
Aug 10, 2009 03:30 PM
