Needa engine to wake up your f-body?
this engine with my STOCK 85 tpi, ran 12.48 thru the 1/4 in a t-top iroc, i must admit traction is almost impossible from a dead stop,hehe

specs are:
350 block '638' casting 1 piece seal, ,30 over
4 valve relief 6cc dish pistons
rods and mains 10/10
all balanced and blueprinted by adger Smith performance
zz4 GMMP camshaft .474/.510 hydraulic roller
186 casing heads, fully ported, PROFESSIONALLY by adger smith
1.94 1.50
9:5.1 compression ratio pump gas friendly!
milodon windage tray, new melling oil pump, new cloyes timing set

with 8* advance, n tpi 3:42 gears and 700r4 trans, i was getting 25 on highway if i kept my foot out of it, nice engine and i didnt even tune the prom, i was running stock 85 350 vette chip, also have complete 85 870 ecm with new chips if needed, that would include teh MAF piggyback ecm:P

im 2 hours from dallas and the same distance from littlerock

engine needs a good home, pics availeable upon request, motor has 8k on it car got hit, i have 2300 invested, $1800obo

 

can you send me some pics to marksmayham@hotmail.com I am in denton just north of dallas.Thanks,Mark

 

engine still bagged on stand, i will sell the shortblock for $1200, if someone would rather breathe a lil more are, for a highflow intake, also have a couple of newer 1 piece seal 250 blocks, and a few older style blocks, also have a nice aftermarket 4130 2pc seal crank freshly turned at 10/10 lotsa stock rods, pistons, oilpans, if i dont have it, i can find it! only thing im short of around here is 400 sbcs