I have some parts left over from a LT1 project:
Diamond pistons for SBC, break in time only these pistons are like new. Owner decided to go SC and pistons were puled out with less than 200 miles on them. 4.030 bore, 5.85 rod 3.75 stroke flat top coated tops and sides have over $1000 into them new. $400 Can get weight and pin sizes if needed.

ATI Balancer for LT1 C4 Corvette. Installed with VERY little use almost NIB. Has all paper work etc. $285


Classic FAST system again almost new. The WBO2 has less than 300 miles and no leaded race gas run through it. It is a bank to bank setup and was orginally setup for optispark but was converted to IPU distributor pickup. I can have it converted BACK to optispark for $150. I have a splice harness that was in C4 Vette along with the injector harness and WBO2 harness. I also have a complete FAST stand alone harness. $750

Crane Cams HI-6 ignition box. This was purchased to dx a bad MSD box and again has little to no use on it. Still in original box part# 6000-6440. $175