[CA] Procharger low profile carb bonnet hat
Thread Starter
Supreme Member
iTrader: (2)
Joined: Sep 2003
Posts: 10,494
Likes: 3
From: Woodland, CA
Car: '02 Z06
Engine: L33 5.7
Transmission: T56
Axle/Gears: Stock IRS
Procharger low profile carb bonnet hat
Up for sale here is a Procharger low profile carb bonnet / hat.
It has a 3" inlet and a 2" height to clear our stock hoods.
It is a pretty basic but sturdy aluminum casting.
About 400miles street use out of it. no scratches or damage whatsoever.
Has a nipple fitting in the back I used for my fuel pressure regulator so it didnt lower pressure under vacuum but it did raise pressure under boost.
Use it for a supercharger application or to make a nice cold air intake for your carb'd application.
Asking $100 plus shipping.
see my other for sale thread for a matching throttle body it was mated to.
https://www.thirdgen.org/forums/engi...ml#post4268302
It has a 3" inlet and a 2" height to clear our stock hoods.
It is a pretty basic but sturdy aluminum casting.
About 400miles street use out of it. no scratches or damage whatsoever.
Has a nipple fitting in the back I used for my fuel pressure regulator so it didnt lower pressure under vacuum but it did raise pressure under boost.
Use it for a supercharger application or to make a nice cold air intake for your carb'd application.
Asking $100 plus shipping.
see my other for sale thread for a matching throttle body it was mated to.
https://www.thirdgen.org/forums/engi...ml#post4268302
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Sep 17, 2020 08:26 AM
GVMV
Engine/Drivetrain/Suspension Wanted
1
Aug 16, 2015 08:01 PM
air, bonnet, camaro, carb, carberators, carbureted, filter, hat, inlet, low, photo, procharged, procharger, profile, sale
