aluminum driveshaft
09-20-2009, 02:16 PM
#1
Supreme Member
Thread Starter
iTrader: (3)
Join Date: Jan 2004
Location: p'cola FL
Posts: 2,311
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 iroc-z/28
Engine: 408 lsx
Transmission: 5800 stall
Axle/Gears: 4.71
aluminum driveshaft
gm 15165400
removed from 2002 ext cab, short bed
its the big forged spicer yoke on the end. not sure if its for the 4l80 or it goes into the transfer case for a 4wd. could easily be swapped out.
use the tube and shorten it, or buy it for the yoke.
this one is 150+ bucks new.
driveshaft measures 68" center of u joint to center of u joint.
driveshaft priced from gm is just over 450 bucks.
50.00+actual shipping cost.
removed from 2002 ext cab, short bed
its the big forged spicer yoke on the end. not sure if its for the 4l80 or it goes into the transfer case for a 4wd. could easily be swapped out.
use the tube and shorten it, or buy it for the yoke.
this one is 150+ bucks new.
driveshaft measures 68" center of u joint to center of u joint.
driveshaft priced from gm is just over 450 bucks.
50.00+actual shipping cost.
10-31-2009, 01:51 PM
#2
Supreme Member
Thread Starter
iTrader: (3)
Join Date: Jan 2004
Location: p'cola FL
Posts: 2,311
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 iroc-z/28
Engine: 408 lsx
Transmission: 5800 stall
Axle/Gears: 4.71
Re: aluminum driveshaft
i have been told this yoke will work for a 4l80 or a th400 swap.
make offer
make offer
Thread
Thread Starter
Forum
Replies
Last Post
