Location: Toronto, Ontario Canada
All prices in CDN dollars, PayPal fees set at 4%, and shipping is extra:

Turbo Buick/Grand National Specific:
3) Mease Performance Engineering 3" aluminum MAF pipe, elbow and K&N filter - $125
5) Two (2) Turbo Tweak v5.6 chips for alky/propane, 83pph injectors, 3000 stall and a stock MAF - $50/pr
6) Two (3) 233 Bosch FPRs & one (1) 237 Bosch FPR - $20/set
8 ) Ashtray switch plate w/two momentary switches - (a BuickGN.com product?) engraved with Alky & Transbrake - $20
11) Billet inlet bell for stock turbo - $40
12) Stock downpipe elbow - $20
13) Stock downpipe & elbow w/gaskets & bolts/springs - $45
17) 3” Dump pipe w/4-bolt flange (bring your own cap & hardware (I never used any )) - $30
18 ) Stock plastic vacuum block w/bolts - $15
19) Stock A/C compressor brace (steel “Y” brace w/two holes added for MAF bracket) - $10
20) Stock ashtray - $5
21) Four (4) new Comp Cams 980 valve springs & twelve (12) stock spring cups - $15
22) WO2 (black out) front fender trim today in okay condition (DS needs a crease removed (I lost a wheel once... once)) - $30/pr
23) IAC relocation harness - $10

Suspension:
1) 34mm hollow front sway bar - $40
2) G-body stock rear springs - $30/pr

Cooling:
1) Aluminum F-Body radiator (w/built in trans cooler) - $100
2) Ford Taurus electric fan w/harness - $25

Exhaust:
2) Two (2) Hedman 3”-2.5” ball flange reducers w/O2 sensor bungs (P/N 21143) – NIB - $40

Wheels:
1) Weld Drag Lites – 15x3.5” & 15x8 (w/3.5” BS) – 5x4.75 bolt circle, includes 165R15 & 275/60R15 tires, 20 lugs & washers and 2 centre caps - $849
2) 2002 Z28 Factory “Snowflakes” – four 16x8 wheels (5x4.75” bolt pattern), includes 245/50R16 GSA tires (worn) and 26x10.5 ET Streets (not mounted) and centre caps and a set of 235/50R16 Toyos Proxes - $300
4)Two (2) Cooper Cobra 215/65R15 tires in good condition – $60/pr
5)Two (2) Hercules 275/60R15 tires in good condition - $110/pr

Engines & Parts:
1) Complete TPI 305 Swap – includes- Full ECM and Chassis harnesses, 7730 ECU (Speed Density), Factory in-tank electric fuel pump and hanger assembly, Intake bellow, upper and lower air boxes and K&N drop-in filters, Dual electric fan assembly w/upper and lower brackets, Stock 1991 LB9 shortblock (rated at 9.3:1 Compression (230hp/300ft-lbs)), Fully ported upper, lower and intake runners, Factory distributor (cap, rotor and MSD Blaster coil), Ford Motorsport "19lb/hr" injectors (rated at 22.5lb/hr at 43.5psi), Holley adjustable fuel pressure regulator, Ported throttle body w/air foil & TPS, Fully ported "193" heads (specs below) w/stainless steel 1.94 intake & 1.5 exhaust valves, guide plates, screw-in studs & factory rocker arms, Full CompCams roller valvetrain w/stock TPI computer friendly cam, Hydraulic roller lifters, pushrods & matching valve springs, Factory valve covers; and Extra TPI gaskets - $1299
3) GM Performance Parts LT4 valve springs (P/N 12495494) – NIB - $35
4) Stock TBSS intake setup (complete w/silencer) w/K&N replacement filter - $75
5) Crane Cam Gen 1 SBC (retro-style) solid roller lifters with rev kit, Gold roller rockers and stud girdles & lock nuts; used and in fair condition - $235
6) Center bolt valve covers (a bit grimy, minor rust spots… but sound) w/grommets and oil cap - $10
7)Stock 1996-00 Vortec intake manifold (has spider injector assy, & what is shown in pictures) - $25

Transmission & Driveline Parts:
2) SS/442 200-4R (CZF/CRF etc) Servo cover (P/N 8635692) and piston (P/N 8633563) w/spring, seals & retainer ring - $10

Miscellaneous Electronics:
1) MSD/Vortech Universal Boost Timing Master (P/N 5462) w/Ford TFI coil adapter harness (P/N 8874) – NIB - $225
3) HKS Type 1 Turbo Timer (silver) - $70

Body & Mechanical Parts:
1) Stock 98-02 Camaro Z28 hood (factory black) - $99
2) 2” Cowl induction hood for ‘81-‘88 Monte Carlo (fiberglass, bolt-on, factory black) - $549
3) 1991 Z28 tail lights - one has a hardly noticeable hair line blem/crack - $40
4) 1991 Z28 Hatch Retractor/Closer/Pulldown/Automatic Latch/Power Release - complete assembly worked when removed from car - $90
5) 1991 Z28 Wiper motor - $10
6) 1993-96 Camaro front license plate bracket - $5

Interior:
1) 1983 Monte Carlo dash plaque and gauge surround – non-SS, maroon in colour - $30
3) B&M “T” Shifter handle (missing switch) - $15

---

Some pictures can be found here: http://whitetrashdesign.ca/images/forsale ; additional pictures available upon request.

All parts are open to offers/negotiation/package deals… don’t be shy!

Email michael_lis@whitetrashdesign.ca or call 289-298-5185

 

I am interested in

3) GM Performance Parts LT4 valve springs (P/N 12495494) – NIB - $35

also what pushrods are you selling?

thx

 

Please email me at the address above with your details.

There are no push rods listed for sale.

 

bump

 

take the trans go shift kit interested in servo also PM me TY

 

PM sent.

 

how much would you like for the Fuel Pressure Regulator

 

Ummm... the price is listed there?

 

Updated list @ top!

 

The roller rockers: Ratio and Self-aligning? May be interested.

 

Unknown and non-self aligning... also the parts will not be separated.

 

Bump... Added new parts!

 

Bump!

 

Still have the taurus fan? (I assume we're talkin the fan with the large shroud). How much shipped to 06095

 

You listed B&m shifter handle, just to be clear is it the slender metal piece that the actual handle screws onto, or the handle itself? I'm looking for the short throw handle and trigger for my shifter out of a different car, I have long throw and its taller than I want it to be, suspect it was a non console application.

 

Hey I know you posted this a while back I was wondering if you still had the taurus fan?

 

interested in the aluminum radiator. could you send photos and will it fit an f body?