Cleaning out the garage.
Thread Starter
Joined: Dec 2005
Posts: 6,499
Likes: 31
From: Macon, GA
Car: 1992 Camaro RS
Engine: Vortec headed 355, xe262
Transmission: T56
Axle/Gears: 9-bolt 3.70
Cleaning out the garage.
Ive got a bunch of random stuff I wondered if anyone was interested in.
I've got a ECM for an 1992 L03 car. It has a Tbichips.com chip in it just to turn off the check engine light for the emissions delete the previous owner did and has lean cruise mode enabled. I had a narrowband A/F gauge in the car and I could see the ECM going into lean cruise so I know it works. Stock chips dont do this. It's for a pretty much a stock L03 though. I had an open element filter and a flowmaster exhaust on it and it ran great, but when I put my long tubes and 3 inch duals on it (in preparation for the engine swap) it didnt run quite right anymore.
I want $30 shipped for it.
I have a pair of rear 91-92 16 inch wheels. $50 takes em. One has a little curb damage. It'd make a great extra pair of wheels for some drag radials or something.



Also, I was told that some places can recondition clutch discs and you can turn pressure plates. Anyway, I've got a used Spec Stage 3 LT1 clutch that I got with my trans when I bought it. It was too worn for me to want to use it, but I hear these might be useful to some people so I figure I'll put it up before I throw it in the trash:

700r4 torque arm mount - $15 shipped

Pair of Grid tail lights. The driver's side has a small crack. I cant feel it on the outside, but you can see light reflecting through it barely. I had to use the black molding near the tag for my klearz project. I'll take $50 shipped for the pair:

I've got a TBI unit from my L03 that's been sitting around for a year or so. $25 takes it.
I've got a ECM for an 1992 L03 car. It has a Tbichips.com chip in it just to turn off the check engine light for the emissions delete the previous owner did and has lean cruise mode enabled. I had a narrowband A/F gauge in the car and I could see the ECM going into lean cruise so I know it works. Stock chips dont do this. It's for a pretty much a stock L03 though. I had an open element filter and a flowmaster exhaust on it and it ran great, but when I put my long tubes and 3 inch duals on it (in preparation for the engine swap) it didnt run quite right anymore.
I want $30 shipped for it.
I have a pair of rear 91-92 16 inch wheels. $50 takes em. One has a little curb damage. It'd make a great extra pair of wheels for some drag radials or something.



Also, I was told that some places can recondition clutch discs and you can turn pressure plates. Anyway, I've got a used Spec Stage 3 LT1 clutch that I got with my trans when I bought it. It was too worn for me to want to use it, but I hear these might be useful to some people so I figure I'll put it up before I throw it in the trash:

700r4 torque arm mount - $15 shipped

Pair of Grid tail lights. The driver's side has a small crack. I cant feel it on the outside, but you can see light reflecting through it barely. I had to use the black molding near the tag for my klearz project. I'll take $50 shipped for the pair:

I've got a TBI unit from my L03 that's been sitting around for a year or so. $25 takes it.
Last edited by InfernalVortex; Mar 28, 2010 at 01:53 AM.
Member
iTrader: (2)
Joined: Nov 2009
Posts: 471
Likes: 0
From: Zanesville, Ohio
Car: 1984 Formula ws6
Engine: 370 LSX
Transmission: 4L80E with a brake and 4500 Stall
Axle/Gears: Moser 9" 4.30 gear
Re: Cleaning out the garage.
R u willing to part with that lt1 bellhousing?? Pm me
Joined: Nov 2005
Posts: 2,346
Likes: 1
From: Naples, FL
Car: 91 RS Camaro, 75 L82 Corvette
Engine: LO3, 383 Stroker
Transmission: 700R4, TH400
Axle/Gears: 4th gen 3.23 posi/LS1 discs, stock
Re: Cleaning out the garage.
I could use that ECM, hit me up.
Thread
Thread Starter
Forum
Replies
Last Post
sailtexas186548
Engine/Drivetrain/Suspension Parts for Sale
8
Feb 17, 2017 03:07 PM
Randomtask2
Interior Parts for Sale
5
Sep 10, 2015 08:37 AM







