Posting this up for a friend. He has a motor he's looking to get rid of. I know nothing about it so I'm going to post what he sent me in the email. He's located in new York but can also be brought to CT in a couple weeks when he comes down and visits.

It is a Chevy 305 tbi engine.
Block is form a 91 Camaro and is 100% worked over.* It was tanked and bored .030 over, new brass freeze plugs and cam bearing were installed.* Block has been painted with 1 coat of chevy orange.* The crank was checked and reinstalled with new main bearings.
The roller cam was reinstalled and timing gears put on.* I purchased brand new pistons and had them put on the rods, but have not gotten them put back into the block.* All It needs is rod bearings to put them in.* I cannot remember if I bought piston rings for them or not yet.* May need those too.
*
Everything else that I have for the engine is from a '93 Caprice.* The heads are the new ('93+) style with improved seals.* They could be tanked and checked by a machinist and at least have new seals put in.* Right now, they are as they where when I took them off the car.* I have the intake and it is all painted up and ready to install.* It is the factory aluminum tbi intake.
*
I have everything else for the motor.* All tins, flywheel, balancer, hardware, distributor, fuel injection, accessory brackets and pulleys.* And about 90% of the wiring and computer*from the caprice.
*
I do have a few sets of exhaust manifolds that have all the smog tubes and such on them.* I also have the air pump and a lot of the other emissions components as well.
*


Price is $500 obo. He's deff willing to negotiate so don't be afraid to offer whatever you have. He just wants it gone as he needs the room for other projects. Contact me through here or my email address at blombardi@rocketmail.com and I'll get answers to any questions you guys have.

 

Is this stuff included?

 

Yes all included