***SOLD***

Here is my basically new Dynomax 3" exhaust (they didn't/don't have a listing for a complete kit like this, but you could put one together through their catalog, if you knew which #'s to order). I also have a 3" Catco HO cat which I am including in this kit. The system is 3" all the way from the high flow cat back to the muffler where 2 2.5" pipes come out on the left hand side under the rear bumper. Similar to the SLP or Banks Power setup. I had this setup on my 88 Pontiac Firebird TBI, and it should fit any small block V8 Third Gen F-body (Firebird / Camaro) with a the TPI setup (my TBI had TPI headers). However, you are responsible for confirming fitment on your own vehicle.

The exhaust was installed but I parted the car out before actually taking it on the road, it was run for maybe an hour over various 10-15 minute stretches while I tuned the motor, and it sounded excellent, deep and throaty. It is essentially a new exhaust (though there is some soot in the pipes from the running process). Includes the slip on clamps as well, as the exhaust was not welded together, this way you can get it fit to your car and then have it welded, or keep it clamped.

The tips are oval and the tape is just there to keep the packing peanuts out of the pipes. This is your chance to buy a complete high performance exhaust for your third generation F-body with no miles on it.

Asking $300 OBO

Buyer pays all shipping costs, but is also available for local pickup (item is located in Orange County, CA).