Hey guys, I'm finally getting a shed next week, so anything I have that I'll never use is going...if not sold getting thrown out. The one thing I'd really hate to scrap is the zero balance flywheel. But, it can only be used on a 1 piece rear seal motor bolted to a t56 in a car with a mechanical clutch. If anybody can use it, give me 25 plus shipping for it and I'll include the McLeod clutch. Also have a stocl LT1 flywheel and a stock t5 flywheel. $10 plus shipping for either one. Also have a steel underdrive crank pulley for a serpentine setup. $20 plus shipping. LT1 wiring harness out of 94 trans am auto trans. $20 plus shipping. Wiring harness with sensors for accel gen6, $50 shipped. Computer controlled HEI distributor with 8.5 MSD wires, $25 plus shipping. 2 pairs of centerbolt valve covers, 1 stock and 1 chrome. Both would clean up nice with some elbow grease. $15 plus shipping for either set. Oh, and if anybody wants the 305 out of my 91(runs but had low oil pressure), $60. That's about what I'll get at the scrapyard for it. All prices are obo, I jast want a few bucks for my time to box stuff up. I'm near philadelphia...if somebody local wants anything come and get it for half price! Actually, if somebody local would want EVERYTHING, come and get it all for $150! I'm going on vacation this week, but whatever doesn't sell by friday when I come home is getting trashed or scrapped. I'm not gonna clutter up my new shed. For pics, give me an email address and I can send some. Feel free to call or text me. 267-377-5923. Thanx, brent.

 

How about $20.00 plus shipping for both set's of valve covers?

 

Shipping quote for the LT1 flywheel to 75119, do you have paypal also? thanks

 

I can do 20 plus for both valve covers. As far as a shippig quote for those and the flywheel, I don't know if I'll have time to get them boxed and a price before I leave later today(I have a hub bearing bad in my pickup that I need to replace before I leave). I will try tho!

 

Btw, I also have a flowmaster after cat y pipe for the dual converter exhaust. Has 2.5 inlets going to a 3in intermediate pipe. The headers and y pipe I got for my 91 are for a single cat and I'm not gonna try to convert the IROC to a dual cat so it's another piece I'll never use. Only had it on car for about 4 months. $20 obo plus shipping. And something that's not 3rd gen related, can I list my snap-on toolbox for sale? Want to get a bigger one...

 

Bump to the top again! I didn't get back from vacation till sunday nite, and been workin every day since so I haven't been home to get any shipping prices yet. I should be home tomorrow tho so I will go and get prices. Sorry for the delay!

 

Hey can you post any pics of the distributor? is it stock ? The seperate coil model? how many miles thanks

 

sent you a pm then realized you put your number in the post