[FL] Solid running 305 chevy engine
Thread Starter
Supreme Member
iTrader: (10)
Joined: Oct 2007
Posts: 1,881
Likes: 2
From: Fl.
Car: 83 Trans Am / 96 Jeep XJ
Engine: 355 / 4.0 I6
Transmission: TH350 / Auto
Axle/Gears: 3.23 10-bolt / 4wd
Solid running 305 chevy engine
Still in the car, you can hear it run.
Selling the engine out of my 83 Trans am, motor has around 100k miles on it, and runs fine, no internal engine problems at all. The only things this engine would benefit from is new valve seals and lifters, as one of the lifters is dying and ticks. I also have the original 700R4 for slae as well, it shifts fine, but when it hits third gear it seems to stumble and lose accelleration until it hits 4th gear. I would probably just throw the transmission in with the deal.
What IS included:
Long block 305, 1pc RMS
Factory 416 Heads
Valve covers, to oil pan
Manifolds
Edelbrock performer intake
What ISNT included:
Accessories
Carb, or distributor
Starter
I am selling because I built a 355 to be swapped into it, and it is now my project car.
Asking $200, or best offer, but I WILL trade for an engine hoist and assistance in removal.
Thanks.
Selling the engine out of my 83 Trans am, motor has around 100k miles on it, and runs fine, no internal engine problems at all. The only things this engine would benefit from is new valve seals and lifters, as one of the lifters is dying and ticks. I also have the original 700R4 for slae as well, it shifts fine, but when it hits third gear it seems to stumble and lose accelleration until it hits 4th gear. I would probably just throw the transmission in with the deal.
What IS included:
Long block 305, 1pc RMS
Factory 416 Heads
Valve covers, to oil pan
Manifolds
Edelbrock performer intake
What ISNT included:
Accessories
Carb, or distributor
Starter
I am selling because I built a 355 to be swapped into it, and it is now my project car.
Asking $200, or best offer, but I WILL trade for an engine hoist and assistance in removal.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post





