[MI] New 406 SBC short block
Thread Starter
Member
Joined: Jan 2000
Posts: 285
Likes: 0
From: New Boston, MI
Car: 92 RS
Engine: 406 SBC
Transmission: 4R70W
Axle/Gears: Moser/Strange 9" 3.73, spool
New 406 SBC short block
New 406 SBC short block
I'm selling my 406 I was building for my Camaro before I sold it.
I'ts a new World Products Motown block. 350 sized mains, large diameter cam, 4.155 bore
Eagle 4340 forged crank 3.75" stroke
Eagle 6" H-beam rods
Arias N20 500 pistons (23 degree) See spec sheet below.
Hellfire rings
Comes with bearings
The block is a factory blemish block. It has a casting flaw on the outer edge of the deck. I had it checked out by Enginecraft and it was fine, nothing critical. See pic below.
The block is fully machined, has the crank sitting in it, cam bearings are in, and ready for assembly besides gapping rings. Pistons are hung on rods.
Looking to get $3200 obo
I'm selling my 406 I was building for my Camaro before I sold it.
I'ts a new World Products Motown block. 350 sized mains, large diameter cam, 4.155 bore
Eagle 4340 forged crank 3.75" stroke
Eagle 6" H-beam rods
Arias N20 500 pistons (23 degree) See spec sheet below.
Hellfire rings
Comes with bearings
The block is a factory blemish block. It has a casting flaw on the outer edge of the deck. I had it checked out by Enginecraft and it was fine, nothing critical. See pic below.
The block is fully machined, has the crank sitting in it, cam bearings are in, and ready for assembly besides gapping rings. Pistons are hung on rods.
Looking to get $3200 obo
Joined: Oct 2001
Posts: 12,223
Likes: 1,148
From: Il
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: New 406 SBC short block
Dang, If you put this up a few months ago it woulda been goooone! Free bump!
Thread Starter
Member
Joined: Jan 2000
Posts: 285
Likes: 0
From: New Boston, MI
Car: 92 RS
Engine: 406 SBC
Transmission: 4R70W
Axle/Gears: Moser/Strange 9" 3.73, spool
Thread
Thread Starter
Forum
Replies
Last Post
dimented24x7
Tech / General Engine
4
Sep 6, 2015 03:51 PM
