[NV] Borla 3.5" catback
Thread Starter
Senior Member
iTrader: (3)
Joined: Oct 1999
Posts: 535
Likes: 0
From: Reno, Nevada
Car: 1991 Formula L98
Engine: 350
Transmission: T-56
Axle/Gears: 3.73:1
Borla 3.5" catback
Custom welded 3.5" intermediate/over axle pipe, with 3.5" in/out Borla XR-1 straight through muffler, with single 3.5" drivers side outlet. Designed to tuck up under the car as much as possible as the car was very low. This exhaust sounded amazing on my supercharged 350 and has only a few hundred miles on it.
Asking $300. Also, flanges are installed so this setup can be installed easily without removing the rear axle or anything like that. Attached is a pic of how it exits the car. I still need to snap some photos of the muffler and overaxle pipe, and I will provide more pictures to any interested parties. Thank you.
Asking $300. Also, flanges are installed so this setup can be installed easily without removing the rear axle or anything like that. Attached is a pic of how it exits the car. I still need to snap some photos of the muffler and overaxle pipe, and I will provide more pictures to any interested parties. Thank you.
Thread
Thread Starter
Forum
Replies
Last Post