parting whole car...tranny gone

how much for the a/c lines, condenser, and a/c box on firewall. shipped to 77573

shipping would be abit. you dont need the compressor?
firewall box, condenser and lines. $140 shipped

Passenger side power rearview mirror shipped to 78211 along with the ground effect left rear behind tire. pm me if possible

how do both fenders look? can you send pics?

rubber brake pedal cover and nose emblem?

Clutch hydraulics available? How much shipped to 99336?

I need some 28 spline 90-92 only third gen axles...

$40 shipped

If it has rear disc brakes I need the rear disc brake proportioning valve thingy that's right underneath the master cylinder. How much shipped to 46110?( Boggstown Indiana) thanks

It does have 4 wheel disk
$35 shipped for prop. Valve.

It's a deal, sending PM.

how much for the whole rear end, shipped to 46804

PM sent and money sent for prop valve. Thanks

pm sent

How much for the door panels? Any pics?

sold

brake pedal cover, nose emblem, and rear view mirror?

I need the front lip GFX shipped to 91761 Let me know if its in good condition

are you willing to sell the tachometer chip in the bottom right corner of the cluster? if so, how much shipped to 71047?

How much for the serpentine set up if you still have it?

pm sent

Steering column shipped to 92780?

Clutch hydraulics showed up, thanks for the fast shipping. This should help get my project off the ground in no time.

Ditto, my rear disk brake prop valve was cheap and showed up quick too. Great seller for others interested. ( I know this should go in feedback forum, just wanted to chime in too)

pm'ed

what condition are the front fenders front bumper and lower bumper ground effex?

Still have rear? Open or posi?

how much for the wiring harness shipped to 48457?

I am interested in the air cleaner intake hose

Do you still have the VSS or did you let that go with the tranny?

I need the peddles too. shipped to 97016

3rd brake light in 100% condition. Let me know shipped to 44125. For 89 IROC-Z.

the lense? its nice. can post pic if interested. $30 shipped

Please post picture. Definitions vary between people. I need the whole assembly (bulbs not really needed but a plus) with screws. The lens and housing together as a complete 3rd brake light with the two screws for mounting it to the spoiler. Thanks.

Do you still have the VSS for the speed 'O'?

Looking for the Engine harness... price shipped to 60446...

Will the heads fit a 87 305 and will a tpi intake base fit the heads if so how much for both shipped to 14812

i have a set of 5.0 tpi heads and the tpi base.
$200 shipped for everything

how are the valves and valve seals in the heads?

they came off a good running motor. been sitting on my shelve for about a year in heated garage

another pic

Would you say there bolt on ready or should i replace seals

sorry been camping since last night. you could bolt them on . honestly i would clean them and paint them and at autozone you could rent a valve spring compressor. put new valve seals in for less than $50. thats what i would do but you could bolt right on.

Again, wiring harness shipped to 60446?

Nevermind.

Is anyone else getting a response?