[NC] T56 conversion crossmember
Thread Starter
Joined: Dec 2000
Posts: 1,954
Likes: 68
From: NC
Car: 1987 Iroc
Engine: 357 Single plane and a Ysi vortech
Transmission: T56
Axle/Gears: 3.50 9"
T56 conversion crossmember
This is a VERY stout crossmember. I used it successfully with my T56 swap. Worked with long tubes as well. It uses the rear factory bolt holes for the front two holes of this, then you just drill and use nuts or metal plates for the rear two. Was very easy(pictures of that process are in my build thread)
It was made at a local race shop.
Just wanting my money back out of it
$80
It was made at a local race shop.
Just wanting my money back out of it
$80
Thread
Thread Starter
Forum
Replies
Last Post
TinnMann2
Canadian Region
16
Jun 18, 2017 05:10 PM
kammi10
Engine/Drivetrain/Suspension Parts for Sale
2
Nov 9, 2015 08:28 PM
tmork454
Transmissions and Drivetrain
0
Sep 29, 2015 06:33 PM