[NJ] Air Condition System, Almost Complete...
Thread Starter
Joined: Jul 2003
Posts: 10,532
Likes: 204
From: NYC / Jersey
Car: 1990 Trans Am GTA
Engine: Turbo 305 w/MS2
Transmission: 700R4
Air Condition System, Almost Complete...
This setup is right off of my '90 GTA. I switched from this system to a non-AC box system off of a F-Body which I paid over a hundred bucks for so I could run my turbo setup. I retained my blower motor because the non-AC box didn't come with one, despite paying that much for it lol. This setup does not include the AC compressor though, if I come across it I will include it for a little more than the asking price, but as of right now it is MIA. Setup worked flawlessly when removed, just needs to be cleaned. The condenser is solid, the protective foil on the condenser was pushed in over the years, but that is only there to protect the tubing underneath and is meant to cave in like that, tubing underneath is fine. $150.00 for everything in the two pics (I'll even throw in the cruise control setup)... 
- Rob


- Rob
Joined: Apr 2010
Posts: 513
Likes: 44
From: New Jersey
Car: 87 Monte Carlo SS
Engine: 89 350TPI Transplant
Transmission: 2004r
Axle/Gears: 3.73
Re: Air Condition System, Almost Complete...
Willing to separate? I can use the two sets of A/C lines shown in the first picture. The one shown in the top of the picture and the one at bottom of the picture that attaches to the A/C compressor.
Junior Member
Joined: Feb 2015
Posts: 4
Likes: 0
From: Conroe TX
Car: 91 Formula
Engine: 406
Transmission: 700r4
Axle/Gears: moser axels with 323 gears
Re: Air Condition System, Almost Complete...
Do you still have it? Id like to get it from you I'm located in Conroe Tx
Thread Starter
Joined: Jul 2003
Posts: 10,532
Likes: 204
From: NYC / Jersey
Car: 1990 Trans Am GTA
Engine: Turbo 305 w/MS2
Transmission: 700R4
Re: Air Condition System, Almost Complete...
Originally Posted by Freakazoid
Do you still have it? Id like to get it from you I'm located in Conroe Tx

Originally Posted by Fred SS
Willing to separate? I can use the two sets of A/C lines shown in the first picture. The one shown in the top of the picture and the one at bottom of the picture that attaches to the A/C compressor.
Thread
Thread Starter
Forum
Replies
Last Post









