[CT] Turbo 400 (TH400) Complete Swap
Thread Starter
Member
iTrader: (3)
Joined: Jun 2013
Posts: 156
Likes: 0
From: CT
Car: 1984 Trans Am
Engine: 355
Transmission: T-56
Axle/Gears: 10 Bolt, Torsen Diff, 3.73's
Turbo 400 (TH400) Complete Swap
I've got the complete TH400 swap out of my 1984 T/A.
-TH400 transmission - Originally out of a truck, so it needs the special driveshaft yoke
- Denny's Driveshaft with the truck yoke, length set up for third gen with 10 bolt rear
- automatic pedals
- BMR Torque arm relocation crossmember for the TH400. Will not come with the BMR torque arm, staying with my T56 swap
- Stock torque converter. Works fine, but has a low stall because it was used for towing originally
- Braided dipstick
- Lokar Kickdown cable and module
-stock flexplate and starter
I think that covers everything, let me know if you think I missed something.
Looking for $1000 for the whole thing. Would prefer not to ship, but could at the buyer's expense. Will listen to offers.
-TH400 transmission - Originally out of a truck, so it needs the special driveshaft yoke
- Denny's Driveshaft with the truck yoke, length set up for third gen with 10 bolt rear
- automatic pedals
- BMR Torque arm relocation crossmember for the TH400. Will not come with the BMR torque arm, staying with my T56 swap
- Stock torque converter. Works fine, but has a low stall because it was used for towing originally
- Braided dipstick
- Lokar Kickdown cable and module
-stock flexplate and starter
I think that covers everything, let me know if you think I missed something.
Looking for $1000 for the whole thing. Would prefer not to ship, but could at the buyer's expense. Will listen to offers.
Thread Starter
Member
iTrader: (3)
Joined: Jun 2013
Posts: 156
Likes: 0
From: CT
Car: 1984 Trans Am
Engine: 355
Transmission: T-56
Axle/Gears: 10 Bolt, Torsen Diff, 3.73's
Re: Turbo 400 (TH400) Complete Swap
BUMP
Everything still sitting around, make me an offer! Can part this out as well if someone needs a TH400 crossmember, driveshaft, etc.
Everything still sitting around, make me an offer! Can part this out as well if someone needs a TH400 crossmember, driveshaft, etc.
Junior Member
Joined: Jun 2016
Posts: 2
Likes: 0
From: New Hampshire
Car: 1984 camaro z28
Engine: 5.7L
Transmission: T5 s speed
Axle/Gears: Not sure yet
Re: Turbo 400 (TH400) Complete Swap
How much for the crossmember, driveshaft, pedals and flexplate? I'm in New Hampshire so would it be possible to ship? I will pay the shipping cost.