SPR Performance TBI
#1
Junior Member
Thread Starter
Join Date: Jul 2016
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Car: '79 Pontiac Trans Am
Engine: 400
Transmission: Super T10 4spd
Axle/Gears: 8.5 10 bolt with 2.73 gears
SPR Performance TBI
Selling my 454 TBI built by Sean at SPR Performance. Mine is the full top-of-the-line build from him. I’m including a GM intake adapter and aftermarket plate so it can be used on any intake.
-Bored to 54mm with throttle blades to match
-Fuel pressure regulator block-off plate installed
-NOS Delco sensors installed
-GM base milled to allow for bolting up to any spreadbore intake
-Thinned throttle shaft for more airflow
-Injectors pod spacer installed for more airflow and better fuel atomization
-All hardware replaced with stainless
$350...this is a smoking deal for the quality that Sean put into this one. Honestly, I wish I could keep this but I came up with some expensive repairs on my daily driver this month and I’m going back to school to start my Masters degree next month. Need to catch up a little bit on my finances.
-Bored to 54mm with throttle blades to match
-Fuel pressure regulator block-off plate installed
-NOS Delco sensors installed
-GM base milled to allow for bolting up to any spreadbore intake
-Thinned throttle shaft for more airflow
-Injectors pod spacer installed for more airflow and better fuel atomization
-All hardware replaced with stainless
$350...this is a smoking deal for the quality that Sean put into this one. Honestly, I wish I could keep this but I came up with some expensive repairs on my daily driver this month and I’m going back to school to start my Masters degree next month. Need to catch up a little bit on my finances.
Thread
Thread Starter
Forum
Replies
Last Post