tpi crap needed
Thread Starter
Member
Joined: Mar 2007
Posts: 122
Likes: 0
tpi crap needed
Tpi Fuel sender
Tpi throttle body position sensor
Tpi wiring harness MAP sensor "manifold absolute pressure" not cut cpmplete wiring hanress
Tpi injectors "possable offer"
oh and this is just for grins can some one help me out with a diagram for the motor. so i can actually see where certain tubes go and where vacculem line are.
but yea let know know waht you got..
thankx for your time
Tpi throttle body position sensor
Tpi wiring harness MAP sensor "manifold absolute pressure" not cut cpmplete wiring hanress
Tpi injectors "possable offer"
oh and this is just for grins can some one help me out with a diagram for the motor. so i can actually see where certain tubes go and where vacculem line are.
but yea let know know waht you got..
thankx for your time
Joined: Aug 1999
Posts: 5,260
Likes: 460
From: RI
Car: 1984 Camaro Berlinetta
Engine: LT1
Transmission: T56 6-speed
Axle/Gears: 4.11 LS1 Rear End
Re: tpi crap needed
I've got a seding unit and a complete ECM harness for an 85 TPI...... Send me a P/M with your ZIP code if your interested....
Supreme Member
iTrader: (1)
Joined: Aug 2003
Posts: 1,428
Likes: 0
From: SW Chicago 'burbs
Car: American Iron Firebird
Engine: The little 305 that could.
Transmission: Richmond T-10
Axle/Gears: Floater 9" - 3.64 gears
Re: tpi crap needed
The TPS and MAP sensor are on the intake I sent you, just to let you know.
Junior Member
Joined: Sep 2007
Posts: 57
Likes: 0
From: mckeesport. pa
Car: 88transam/ 86 iroc-z/ 64 corvette
Engine: ta 400ci tpi/ iroc 327 / vette 327
Transmission: ta 5 speed/ iroc 700r4/ vette m-22
Axle/Gears: ta 3:42/ iroc 3:73/ vette 4:11
Re: tpi crap needed
Tpi Fuel sender
Tpi throttle body position sensor
Tpi wiring harness MAP sensor "manifold absolute pressure" not cut cpmplete wiring hanress
Tpi injectors "possable offer"
oh and this is just for grins can some one help me out with a diagram for the motor. so i can actually see where certain tubes go and where vacculem line are.
but yea let know know waht you got..
thankx for your time
Tpi throttle body position sensor
Tpi wiring harness MAP sensor "manifold absolute pressure" not cut cpmplete wiring hanress
Tpi injectors "possable offer"
oh and this is just for grins can some one help me out with a diagram for the motor. so i can actually see where certain tubes go and where vacculem line are.
but yea let know know waht you got..
thankx for your time
Thread
Thread Starter
Forum
Replies
Last Post
beachrodder
Tech / General Engine
7
Aug 25, 2015 08:05 AM
