Crossmember to Frame Brace

Reply Subscribe

Thread Tools

Search this Thread

Feb 3, 2008 | 03:45 PM

92RS_Ttop

Thread Starter

Supreme Member

iTrader: (3)

Joined: Jun 2007

Posts: 2,359

Likes: 5

From: Pennsylvania

Car: 1992 Camaro RS

Engine: Rebuilt 350 going in after paint

Transmission: WCT5, 7k & counting behind the 350

Axle/Gears: 4thgen disc rear w/ 3.73 Posi

Crossmember to Frame Brace

I'm puting my 92 RS back together and noticed that the triangular brace that bolts between the engine crossmember and the front subframe on the driver's side is bent and doesn't fit anymore. I'd like to replace it since I welded the new front clip in place just in front of this brace and was wondering if anyone had an extra one in good shape they were willing to sell for a reasonable price. Shipping would be to 15963. I have attached a picture of what they look like just in case I'm not being very clear about this.

Thanks in advance.

Attached Thumbnails

Feb 3, 2008 | 04:04 PM

jtmiller92

Senior Member

iTrader: (42)

Joined: Jun 2001

Posts: 929

Likes: 10

From: Nicholasville,KY

Car: 1992 Camaro RS

Engine: 415ci LS3

Transmission: T56

Axle/Gears: 3.89

Re: Crossmember to Frame Brace

Though I had some of these but couldnt find them. Only one I have is the one to the far right in your pic, goes under the driverside fender area where the steering box bolts go through. Dont have the other two.