I'm looking for a t-56 trans. I also need lt-1 bellhousing, clutch, flywheel, 4thgen pedals etc for a swap into my 85 T/A behind a gen 1 (2 pc rear main seal) sbc.
Thanks!

 

I got one. Im looking for $1700 for the complete setup. All you would need is a piot bearing, pedals and modify your crossmember. Included is a 4th gen crossmember. Might be able to do something with it.

 

Thanks man! I'll pass. I'm lookin at one thats here local for around 800.oo. I appreciate it though.

 

Do you have the flywheel and crossmember? I have a Centerforce conversion flywheel for a two-piece and a Spohn T56 crossmember. $300 plus shipping for the combo.

 

Sorry it took so long to get back. I broke my right hand on the 6th and had it re-set on thurs. (outch!) I am interested, wesilva! send me pics? is the crossmember for the factory-length torque arm? Thanks!

 

It only mounts the tranny. You'll have to hook up the torque arm to the transmission. Judging by the this article, it looks like a straight swap.

http://www.skulte.com/T56.html

I would do a search on the transmission board.

PM me your e-mail address if you still want pics.

 

pm sent, wesilva.

 

I have a slightly used Centerforce dual friction pressure plate and clutch setup for the T56. Part number DF039020. It sells new through Summit for $610. I'm looking for $250. The two photos show that the disc has quite a bit of pad left on each side. PM if you're interested. Thanks.





Well, I just noticed that you are putting this behind a 2-piece rear block. This setup is for the flywheel on a 1-piece block. I don't think it'll work for your situation.

 

pm me if you still need pedals.-art