As the title says, I'm looking for headers and a y-pipe. I want the headers to be short tubes, at least a 1 5/8" primary tube, and a 3" collector. Do dents or holes in anything. Let me know what you got?

Mike

 

I'm not sure of the collector size, but would these work?

https://www.thirdgen.org/forums/engi...-possible.html

 

What part number are they? If that's a stock y-pipe, then it either has reducers (doesn't look like it) or it has 2.5" collectors.

I'm hoping to get a set without air fittings.

 

well its a hedman y-pipe..... but its prolly 2.5" collectors

good luck with you search

-jason

 

Thanks, I think I'll need it.

 

Found these on craigslsit for you if they'll work.
*****He has a set of hooker Competition headers with the 3 inch collector & adapters, gaskets, bolts and installation instructions for 1982-92 Camaro and 1982-92 Firebird, Trans Am call him at 269-744-8215 . these have not been mounted.****** you can also you them for custom mods....!!!! they will bolt to a 350 just fine!!

**Specs on Headers
*****1-5/8" Primary Tubes
*****3" Collector
*****High Temp Black Paint
*****Shorty Style


Location: Portage, MI

 

Thanks, I'll probably call the person tomorrow afternoon. Do you know if he has the y-pipe too?

 

I only read the ad. Call him to find out and good luck.

 

PM'ed you. i have a set of Edelbrock Headers and y-pipe. Everthing is jethot coated and the AIR tubes are cut off and sealed. 3" outlet to the cat. asking 215.00 plus shipping costs from NJ

 

Have a complete set of eldbrock headers w/y-pipe They do have air tube on them though. Curently y-pipe is still conected to a dual cat pipe asm. that has had the cats removed and stright pipes weld in. This all was mated to a new hooker cat back system. Looking to get $350.00 on pick up for complete asm.(engine to tail pipe set up)