[PA] I need a few items!
Thread Starter
Member
iTrader: (1)
Joined: Oct 2009
Posts: 108
Likes: 0
From: PA
Car: 86 Trans am
Engine: workin on a 383 for it!
I need a few items!
All this will be going into a 1986 Pontiac trans am unibody, running a SO FAR stock J chevy 305 motor, rwd
Alright first I wanted to get a performance water pump but keeping it mechanical
I was also wanting to look for a rear drive shaft hopefully aluminum but again above stock performance
Let me know if any one has any wilwood front calipers, or just above stock calipers for the front
Above stock mechanical fuel pump
Performance master cylinder
Performance parts for rebuilding rear brake drums to above stock
A nitrous plate for a spread bore intake with an hp range from 50-150 any where in that range is fine
Braided stainless steel break lines, for on any part of the vehicle
I am also looking for a 200 mph ultra lite spdeo like this style http://www.summitracing.com/parts/ATM-4496/
Also looking for a panhard bar the tubular style
Lower control arms
Steering brace
Torque arms
Trailing arms
Strut tower brace
Performance tie rod sleeves
Any catch tank this or close to this style
http://www.summitracing.com/parts/CTR-80-223/
ive been trying to find a street scoop intake like this one as well
http://www.summitracing.com/parts/SUM-G3108-1/
PM me with offers and please either post a pic on here pm me or e mail me these are parts I am wanting to have by at least the end of summer so there is a good time frame in witch I will be buying
Thanks
Brenden : )
Alright first I wanted to get a performance water pump but keeping it mechanical
I was also wanting to look for a rear drive shaft hopefully aluminum but again above stock performance
Let me know if any one has any wilwood front calipers, or just above stock calipers for the front
Above stock mechanical fuel pump
Performance master cylinder
Performance parts for rebuilding rear brake drums to above stock
A nitrous plate for a spread bore intake with an hp range from 50-150 any where in that range is fine
Braided stainless steel break lines, for on any part of the vehicle
I am also looking for a 200 mph ultra lite spdeo like this style http://www.summitracing.com/parts/ATM-4496/
Also looking for a panhard bar the tubular style
Lower control arms
Steering brace
Torque arms
Trailing arms
Strut tower brace
Performance tie rod sleeves
Any catch tank this or close to this style
http://www.summitracing.com/parts/CTR-80-223/
ive been trying to find a street scoop intake like this one as well
http://www.summitracing.com/parts/SUM-G3108-1/
PM me with offers and please either post a pic on here pm me or e mail me these are parts I am wanting to have by at least the end of summer so there is a good time frame in witch I will be buying
Thanks
Brenden : )
Member
iTrader: (7)
Joined: Sep 2003
Posts: 267
Likes: 0
From: Coupeville, Washington
Car: 1986 IROC T-TOP
Engine: 350
Transmission: 700-R4
Re: I need a few items!
I've got a double adjustable tubular panhard rod for sale. Was going to lower my car but decided not too. Have new lowering springs if interested too. I will sell you the panhard for $110 shipped.
Thread
Thread Starter
Forum
Replies
Last Post
bigjay89gta
Engine/Drivetrain/Suspension Parts for Sale
12
Oct 15, 2015 08:04 AM
e3pres
Engine/Drivetrain/Suspension Parts for Sale
1
Sep 9, 2015 01:51 PM