looking for a tpi set up
Thread Starter
Member
Joined: May 2010
Posts: 145
Likes: 0
From: Richmond VA
Car: 83 camaro z28, 92 xj
Engine: 305 Crossfire (lu5)
Transmission: 700r4
Axle/Gears: richmond gear 3.73:1
looking for a tpi set up
i have the 305 crossfire.. i want rid of it.. i need the whole set up, everything that i would need to switch it over. hit me up if you have it.
Joined: May 2005
Posts: 728
Likes: 1
From: Toronto, Ohio
Car: 1991 Trans Am GTA
Engine: 355
Transmission: 4L60
Axle/Gears: 4th gen 10 bolt 3.42 posi
Re: looking for a tpi set up
If you still need a TPI, I have the engine parts of it. Its off a 91 GTA 350. I have dent free runners, plenum, lower intake, throttle body, and fuel rails from a 87 Vette which can be made to work by routing two fuel lines. They also include 24 lb. injectors, but one is missing the pintle cap and O rings (can be replaced). Some bolts are missing as I had to use them to install my SuperRam.
Make me an offer if interested.
Make me an offer if interested.
Senior Member
iTrader: (10)
Joined: Jan 2009
Posts: 718
Likes: 1
From: Edmonton, Alberta.
Car: 1988 Pontiac Trans Am GTA.
Engine: 385 stroker sbc
Transmission: TKO600
Axle/Gears: Moser 9" 3.70 Wavetrac
Re: looking for a tpi set up
Still interested Spike?
And if you've found one you should state it.
And if you've found one you should state it.
Junior Member
Joined: Jun 2010
Posts: 10
Likes: 0
From: Kansas
Car: 87 Camaro
Engine: Vortec 454 MFI
Transmission: T-5 5 spd
Re: looking for a tpi set up
I have a 86 Camaro Z28 TPI intake w/computer. Shoot me an offer if you are still looking.
Last edited by FJackson4904; Jun 17, 2010 at 12:29 AM.
Senior Member
iTrader: (10)
Joined: Apr 2007
Posts: 773
Likes: 0
From: The Pocono Mountains, PA
Car: 1987 Firebird, Dad bought it new
Engine: 5.7L Vortec w/ LT4 Hot cam
Transmission: 700r4 transgo shiftkit 2600 stall
Axle/Gears: 3.42 '02 SS 6 spd rear
Re: looking for a tpi set up
i got a harness and computer 24# injectors, throttle and tv cables and tb ill take 425 shipped for all of it the harness is SUPER complete you can replace your whole cars wiring with it its got relays brackets bulbs EVERYTHING that was attatched to the harness is there pm me thanks i even got a bellows for the tb to mafs and the intake Y
Last edited by FlippindaBird; Jun 29, 2010 at 10:22 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 12, 2015 03:41 PM