[IN] 350 Block 60 over
Thread Starter
Junior Member
Joined: Jun 2003
Posts: 47
Likes: 0
From: Overland Park, KS
350 Block 60 over
Wanted, fresh ready for a rebuild 1-piece seal 350 block that is 60 over, I only need the block.
If it has a little rust that be honed out it's fine, but bore must be good.
Located in Southern IN
Thanks
Chris
If it has a little rust that be honed out it's fine, but bore must be good.
Located in Southern IN
Thanks
Chris
Junior Member
iTrader: (1)
Joined: Jan 2008
Posts: 3
Likes: 0
From: Lansing, Michigan
Car: 90,94,96 C4, 93 F 07 K3500
Engine: L98, LT1
Transmission: M6
Re: 350 Block 60 over
Chris,
I use late model blocks for my NHRA L98 motors; I would be a little nervous about using one that is .060 overbore with out filling the block. These blocks were really never intended to be bored that large. All of the blocks that I use have been filled to the bottom of the soft plugs to support the cylinder.
I use late model blocks for my NHRA L98 motors; I would be a little nervous about using one that is .060 overbore with out filling the block. These blocks were really never intended to be bored that large. All of the blocks that I use have been filled to the bottom of the soft plugs to support the cylinder.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM
Eric-86sc
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 24, 2015 09:01 PM