85 MAF needed
Thread Starter
Junior Member
Joined: Jan 2010
Posts: 11
Likes: 0
From: Puerto Rico
Car: 1986 IROC-Z
Engine: 305 Q-jet
Transmission: 700R4
Axle/Gears: 3.73
85 MAF needed
I need a working MAF for an 85 ecm and harness i bought a TPI setup (vendor said it was 88 but it was an 85 one >_>) no other maf will work with it, i read, only one for 85. so now im stuck cause i can't find the 85 MAF or the ones i found cost almost 400 bucks, damn!! that's what i paid for the TPI so i either find a MAf that works with it, or find a newer harness with ecm and sensors (expensive also) or get rid of the damn thing and leave my car in crappy tbi setup. Willing to trade the TPI set up too for some parts that i need now too, need a driver side floor pan (no rust), crankshaft pan, brake master cylinder, dual snorkel air cleaner (if I desist from the TPI). anyways my shipping address is 00957 US territory. Any ideas on what i should do? I'm open to some technical advice and/or suggestions.
Thread
Thread Starter
Forum
Replies
Last Post
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 25, 2015 11:49 PM




