[MO] Found - please lock
Thread Starter
Joined: Sep 2005
Posts: 6,258
Likes: 6
From: O'Fallon, MO
Car: 1991 Z28 convertible built 3/1/1990
Engine: Cammed 6.0L LSX
Transmission: T56
Axle/Gears: custom Ford 8.8", 4.10 gears
Found - please lock
I need the engine side of the motor mounts. Not the rubber bushing part that goes on the k member but the stands that bolt to the block. I need a set for a V8 car and need them asap.
Let me know a price with shipping to 63303. Thanks!
Let me know a price with shipping to 63303. Thanks!
Joined: Aug 1999
Posts: 5,259
Likes: 459
From: RI
Car: 1984 Camaro Berlinetta
Engine: LT1
Transmission: T56 6-speed
Axle/Gears: 4.11 LS1 Rear End
Re: motor mount stands needed
Pass and Drivers side Clamshells: $30 + shipping. ($13 Priority / insured )
I blasted them, coated in etch and repainted silver. They were not rusty so the only pitting is very minor and on the inside of the clamshell. I've handled them for mock-up so they have some minor scratches,...... but a quick scuff/spray will make them look new again.
Send a PM if your seriously interested.
I blasted them, coated in etch and repainted silver. They were not rusty so the only pitting is very minor and on the inside of the clamshell. I've handled them for mock-up so they have some minor scratches,...... but a quick scuff/spray will make them look new again.
Send a PM if your seriously interested.
Thread Starter
Joined: Sep 2005
Posts: 6,258
Likes: 6
From: O'Fallon, MO
Car: 1991 Z28 convertible built 3/1/1990
Engine: Cammed 6.0L LSX
Transmission: T56
Axle/Gears: custom Ford 8.8", 4.10 gears
Re: motor mount stands needed
Still needing these.
Thread Starter
Joined: Sep 2005
Posts: 6,258
Likes: 6
From: O'Fallon, MO
Car: 1991 Z28 convertible built 3/1/1990
Engine: Cammed 6.0L LSX
Transmission: T56
Axle/Gears: custom Ford 8.8", 4.10 gears
Re: motor mount stands needed
Funds sent. Thanks John.
Thread
Thread Starter
Forum
Replies
Last Post
Zachattack0925
Transmissions and Drivetrain
4
Aug 12, 2015 09:52 PM