[SC] Lots of Parts Needed
Thread Starter
Member
Joined: Sep 2011
Posts: 152
Likes: 0
From: Florida
Car: 1991 Pontiac Firebird Trans Am
Engine: 1987 Chevy 355 TPI Mild Cam
Transmission: 5-Speed T-5 WC
Axle/Gears: 3.42
Lots of Parts Needed
I need the following parts for a 1991 Firebird 350 manual,
- Push Rods (all 8)
- Engine Oil Cooler, I don't need the part that matches up to the block just the
lines and the heat exchanger.
- Metal Radiator Hoses
- Water Pump, in good/excellent condition
- PROM chip, 350 programmable would be nice but not a must for the right price
- Radiator in excellent condition
- A/C heat exchanger/radiator thing
Wrong area but if you have it great
- Black Carpet (manual)
- Black Headliner (T-Tops)
Thanks!
- Push Rods (all 8)
- Engine Oil Cooler, I don't need the part that matches up to the block just the
lines and the heat exchanger.
- Metal Radiator Hoses
- Water Pump, in good/excellent condition
- PROM chip, 350 programmable would be nice but not a must for the right price
- Radiator in excellent condition
- A/C heat exchanger/radiator thing
Wrong area but if you have it great
- Black Carpet (manual)
- Black Headliner (T-Tops)
Thanks!
Last edited by Termanalor117; Jun 4, 2014 at 03:40 PM.
Re: Lots of Parts Needed
WP, mounts, knock sensor, TOB, bushing, OPSU all would be easier to get from a parts store. Half those you would not want to get used parts
I have brand new black carpet For $150 shipped
Classic industries
I have brand new black carpet For $150 shipped
Classic industries
Thread Starter
Member
Joined: Sep 2011
Posts: 152
Likes: 0
From: Florida
Car: 1991 Pontiac Firebird Trans Am
Engine: 1987 Chevy 355 TPI Mild Cam
Transmission: 5-Speed T-5 WC
Axle/Gears: 3.42
Re: Lots of Parts Needed
Yeah I came to find that out after looking at the prices online.
Is it the full front and back?
Is it the full front and back?
Joined: Aug 1999
Posts: 5,266
Likes: 463
From: RI
Car: 1984 Camaro Berlinetta
Engine: LT1
Transmission: T56 6-speed
Axle/Gears: 4.11 LS1 Rear End
Re: Lots of Parts Needed
Got carpet,...... a few that are original used fronts, a barely used aftermarket front, as well as a couple original used rear.
Got the factory oil cooler - No lines
& I should have at least 1 set of center-bolt rods leftover too.
If you need these pieces get bacl to me with your ZIP code and I'll reply with some pics and shipping estimates.
Got the factory oil cooler - No lines
& I should have at least 1 set of center-bolt rods leftover too.
If you need these pieces get bacl to me with your ZIP code and I'll reply with some pics and shipping estimates.
Thread
Thread Starter
Forum
Replies
Last Post







