Need parts
Thread Starter
Senior Member
Joined: Aug 2010
Posts: 680
Likes: 2
From: Lincoln, NE
Car: 86 Iroc-Z28
Engine: 5.3
Transmission: 4l60
Need parts
Looking to buy a few parts again
-4l60e trans brackets(circled in pic)
-ARP head stud p/n 234-2316(new)
-Ls6 ported oil pump(new)
-Center caps for camaro wheels(pic below) only need two may buy full set
-Powersteering pump pulley
If for any reason theres somebody selling thirdgen stuff(umi/spohn) need
-Sfc's(UMI)
-Panhard bar dble adj.
-Lcarb's
-Caster camber plates
-Strut tower brace
-4l60e trans brackets(circled in pic)
-ARP head stud p/n 234-2316(new)
-Ls6 ported oil pump(new)
-Center caps for camaro wheels(pic below) only need two may buy full set
-Powersteering pump pulley
If for any reason theres somebody selling thirdgen stuff(umi/spohn) need
-Sfc's(UMI)
-Panhard bar dble adj.
-Lcarb's
-Caster camber plates
-Strut tower brace
Last edited by 86_irocz-28; Nov 5, 2014 at 03:01 PM.
Joined: Aug 1999
Posts: 5,277
Likes: 469
From: RI
Car: 1984 Camaro Berlinetta
Engine: LT1
Transmission: T56 6-speed
Axle/Gears: 4.11 LS1 Rear End
Re: Need parts
Got another 3rd gen 700R4 tailshaft,.... not the one pictured, but identical. Same terms apply.
https://www.thirdgen.org/forums/engi...t-housing.html
Pretty sure I've still got an old tranny I can pull a crusty housing from too that would be a bit cheaper.....
Send me a PM if you need more info.
https://www.thirdgen.org/forums/engi...t-housing.html
Pretty sure I've still got an old tranny I can pull a crusty housing from too that would be a bit cheaper.....
Send me a PM if you need more info.
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
Nov 14, 2015 12:02 AM