v-6 to v-8 question
Thread Starter
Junior Member
Joined: Oct 2002
Posts: 86
Likes: 0
From: Gassville, AR
Car: 86' camaro s/c
Engine: 357
Transmission: th350
v-6 to v-8 question
I have an 86 camaro w/ a 2.8 and 700r4. i'm putting my 350 sbc in it w/ a th350. i can't seem to find an 82 200 driveshaft or crossmember anywhwere. Any ideas? thanks
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
1) Post a "wanted" on the classifieds forum of this board.
2) Have a longer shaft made by a driveshaft shop. Buy the crossmember/torque arm kit from Spohn (excellent upgrade).
2) Have a longer shaft made by a driveshaft shop. Buy the crossmember/torque arm kit from Spohn (excellent upgrade).
Last edited by five7kid; Oct 30, 2002 at 04:10 PM.
Junior Member
Joined: Aug 2002
Posts: 34
Likes: 0
From: Northwest PA
Try here http://www.geocities.com/motorcity/g...ro/index2.html
Or your local junkyard that has a parts locator service.
Summit also carries the torque arm kit.
Or your local junkyard that has a parts locator service.
Summit also carries the torque arm kit.
Last edited by CLH; Oct 29, 2002 at 02:51 PM.
Thread
Thread Starter
Forum
Replies
Last Post