V8 engine with V6 T5, Need clutchplate, Help
Thread Starter
Junior Member
Joined: Jun 2004
Posts: 7
Likes: 0
Car: 1984 Camaro 350 RV cam, Welded rear, 1987 Cutlass(330hpSBC), 1978 Chevy Truck, 1983 Mazda Rx7(getting SBC)
Engine: 350 RV cam
Transmission: T5(v6)
V8 engine with V6 T5, Need clutchplate, Help
I have an 84 camaro with a 2.8 V6, i already have a v8 and i want to put it in, What do i have to do to use a v8 with a v6 T5 transmission?
I know I have to use the v8 bellhousing but i need a 10.5 inch clutchplate with a 14 spline center.
Where do I find one?
I know I have to use the v8 bellhousing but i need a 10.5 inch clutchplate with a 14 spline center.
Where do I find one?
Supreme Member
iTrader: (2)
Joined: Jan 2001
Posts: 4,149
Likes: 3
From: Tampa, FL, USA
Car: 93 240SX
Engine: LQ9
Transmission: T56
Axle/Gears: 3.54 R200 IRS
www.baycityclutch.com call them up, tell them what you want, pay up and wait a few days.
Thread Starter
Junior Member
Joined: Jun 2004
Posts: 7
Likes: 0
Car: 1984 Camaro 350 RV cam, Welded rear, 1987 Cutlass(330hpSBC), 1978 Chevy Truck, 1983 Mazda Rx7(getting SBC)
Engine: 350 RV cam
Transmission: T5(v6)
I didn't know you could use a 9 inch clutch plate with a 10.5 inch flywheel and pressure plate. i talked to someone and the said it would slip easy.
Supreme Member
iTrader: (2)
Joined: Jan 2001
Posts: 4,149
Likes: 3
From: Tampa, FL, USA
Car: 93 240SX
Engine: LQ9
Transmission: T56
Axle/Gears: 3.54 R200 IRS
It works fine, the early V6 one is 9 11/16, i ran one for quite sometime, however bay city can build you one the proper diameter which is what im running now.
