building my 350
Thread Starter
Member
Joined: Jun 2006
Posts: 105
Likes: 0
From: dallas ga
Car: 91 rs
Engine: 350
Transmission: 700r4
Axle/Gears: 4.10
building my 350
i am building a 350 for my 91 rs and i am having trouble pickin out a bottom end set up i dont know what parts to go with. i wont it to all be stock exept im gonna bore it .030 over and maybey go with a 400 crank not sure yet but who should i get my parts from im sorry if i sound stupid but this is my first motor thanx for the help
Joined: Sep 2004
Posts: 2,777
Likes: 7
From: Casselberry, FLA
Car: 88 V6 'bird/89TBI bird/85 T/A
Engine: 2.8/TBI/TPI
Transmission: V8 T-5/700R4 x2
Axle/Gears: 3.42 open/2.73 open/ 3.27 9 bolt
Re: building my 350
Personally, I like PAW, but I have dealt with Summit and Jeg's with no complaints.
Just make sure you get a crank kit that gives you pistons, rods, and crank all together. Make sure that you order this kit for the year of your engine block so that the rear main seal is right. You don't want to deal with too much weirdness on your first go around.
Just make sure you get a crank kit that gives you pistons, rods, and crank all together. Make sure that you order this kit for the year of your engine block so that the rear main seal is right. You don't want to deal with too much weirdness on your first go around.
Senior Member
iTrader: (3)
Joined: Oct 2004
Posts: 805
Likes: 3
From: Charleston, SC
Car: '85 TA
Engine: 350 turbo
Transmission: T56
Axle/Gears: 3.70 posi 9bolt
Re: building my 350
You might try engine shops in your area. They usually have a good selection of parts, and you can also get their opinions on what components would match up well.
Thread
Thread Starter
Forum
Replies
Last Post
Eric-86sc
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 24, 2015 09:01 PM