I'm not sure this is the right forum for this, but I'll give it a shot. Has anyone ever swapped a complete 350 tpi out of a 3rd gen into something other than a third gen? If so did they use the original harness? I don't have the funds available to go buy a aftermarket wiring harness like most people do. After searching a number of sites where people have done the conversion, I have yet to find any definitive answer to the stock wiring harness. I.E. what wires can I eliminate and what must remain.
Any links which will help me out would be great

 

I have a SD 90-92 350 TPI ECU and harness that has allready ben trimmed that I would trade for a 305 SD set up with a stock harness Let me know if you a interested
Thanks Shawn

 

Mine wasn't a sd harness,what I was hoping to get was some info from some one who had done a tpi swap in an older vehicle. And had used the original harness, but it looks like from the lack of replies that no one one this board has done it.