Getting started... the block
Getting started... the block
I am making a 383 for a swap. The first thing I need is the engine block... mainly, its gotta be a 350 with a single piece rear main seal. How can I tell if an engine my buddy has sitting in his garage is one? Visually, casting numbers?
Thanks,
Douglas
Thanks,
Douglas
Supreme Member
Joined: Dec 1999
Posts: 1,237
Likes: 1
From: Reno, NV
Car: yep
Engine: uhuh
Transmission: sure does
AS far as the one peice rear main...just look at it.
If you want an I.D. on what it is get the casting # (located on the rear ledge of the block where the top trans bolts are) and go to www.mortec.com and check them out.
------------------
ASE Mechanic/Machinist/Smog Tech
1999 NBM Trans Am
1986 Chevy 3/4 ton pick up
1981 corvette
1995 Kawi ZX6R
GO #3
If you want an I.D. on what it is get the casting # (located on the rear ledge of the block where the top trans bolts are) and go to www.mortec.com and check them out.
------------------
ASE Mechanic/Machinist/Smog Tech
1999 NBM Trans Am
1986 Chevy 3/4 ton pick up
1981 corvette
1995 Kawi ZX6R
GO #3
Thread
Thread Starter
Forum
Replies
Last Post
skinny z
Engine/Drivetrain/Suspension Parts for Sale
5
Oct 5, 2015 06:23 PM