358 swap
Thread Starter
Junior Member
Joined: Mar 2001
Posts: 30
Likes: 0
From: simpsonville,s.c.
358 swap
Ihave a 1990 G.T.A. W/ the 305 tpi i plan on installing a new engine here are the spects
350 bored 40 over 6" lunoti rods srp pistons dart iron eagle heads 200cc runners 2.02/160 valves 3 angle valve job ported and polished ultradyne cam 288/296 int. 223 exh. 231 .530 int. .552 exh. lobe sep is 112 the cam was degreed 4 advanced. i have the slp runners and edlebrock intake that i plan on siemienes . my question is can i use 24# injecters w/ my ecm untile i get a chip burned will i have any problems?? thanks VAPER....
------------------
350 bored 40 over 6" lunoti rods srp pistons dart iron eagle heads 200cc runners 2.02/160 valves 3 angle valve job ported and polished ultradyne cam 288/296 int. 223 exh. 231 .530 int. .552 exh. lobe sep is 112 the cam was degreed 4 advanced. i have the slp runners and edlebrock intake that i plan on siemienes . my question is can i use 24# injecters w/ my ecm untile i get a chip burned will i have any problems?? thanks VAPER....
------------------
Thread
Thread Starter
Forum
Replies
Last Post
Hello, Michael
Engine Swap
8
Aug 20, 2015 03:19 PM