350 problem
Thread Starter
Member
Joined: Jun 2010
Posts: 105
Likes: 0
From: Indianapolis, Indiana
Car: 88' Z
Engine: 350 .60 over
Transmission: W/C T5
Axle/Gears: 3.23
350 problem
im currently building my 350 bored 60, and ive ran into a problem
im checking my rod side clearance and i got .25 inch is this way too much ?
i got a book that says its suppost to be between .8 and .15
im checking my rod side clearance and i got .25 inch is this way too much ?
i got a book that says its suppost to be between .8 and .15
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: 350 problem
Sure you're not missing some 0's in those measurements?
Yes it's high. Not a lot you can do about it without changing parts.
Yes it's high. Not a lot you can do about it without changing parts.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM